Note: If you recently upgraded to Win10 and the V3.2.0.0 driver was previously installed on your computer, you will only need to select it again. If Windows does not automatically load the proper driver, a caution If this occurs, you Must backdate your driver to 3.2.0.0 It was done to prevent use of the cloned chip. The cable is inserted into the radio, the transmitter will turn on. This When opening Device Manager, the Yellow Caution Triangle may not appear, however, when Windows may attempt to automatically load the Prolific driver 3.6.xx.xxx when inserting your cable. The last compatible Prolific driver was v3.3.2.105. The latest driver installed by Windows (Vista, 7, 8.1 and 10) is not compatible with these chips. Nearly every programming cable that is detected by Windows as having a Prolific chip was manufactured with an unauthorized or cloned copy of the Prolific PL2303HXA chip. Not, the driver and procedure can be found at this Link.ĭrivers for the Silicon Labs chipset (CP210x) should alsoĭownload automatically. The driver should also download automatically. Many Baofeng and generic programming cables are shipping with the WCH chipset (CH340/341). Not all provided CDs come with the correct drivers.īy using Windows Device Manager, you should easily be able to determine whichĬables with FTDI chipset (FT232R) will automatically download the Not all cables load the correct driver automatically. Any suggestion on a solution would be greatly appreciated.Programming cable Must have the correct driver installed The only thing that I know of that's changed since I was successful early this year are the numerous Win 7 upgrades. When I run the FTDI executable installation file it runs and I get two green check marks and a "Ready to use" status but still nothing works and the Hardware Manager still says that the drivers are not installed (Code 28). I've downloaded the latest VCP drivers from FTDI to no avail. When I try to update the driver I get a message saying that Windows can't find the driver for this device. Device Manager shows the FT232R USB UART device under the heading of Other Devices but the properties for this device says the drivers aren't installed. When I connect it, it tries to load the driver(s) but I get an error window saying "Device driver software was not successfully installed". Now I'm unable to communicate with the Nano. I successfully installed Arduino SW and developed sketches which I was able to load and execute early this year.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |